I am an Electronics Expert & Tool Ninja

Today I installed the new Shark Guard on my table saw, fired it up, cut a chunk out of some grade XX phenolic sheet, drilled a few holes in a Hammond aluminum chassis, grabbed some hex standoffs and screws, and made…THIS:

That’s going to be a 6021-powered guitar amp. A 6021 is a subminiature tube about an inch and a quarter long.

The Shark Guard is wonderful. It even has a dust port on it, so I can attach a shop vac.

I cut that panel out, taped it to the chassis, and drilled the mounting holes through both items. The holes are perfectly round; I guess the board held the bit nice and steady. So far, it’s beautiful.

I love my tools so much. This was a breeze!

Ps. 37:4; Zech 4:10