It Never Takes 5 Minutes

I have some information for anyone who is having a hard time installing a new trigger group in a Ruger 10/22 rifle or pistol. This is supposed to be a 5-minute job, and of course, with all my tools, I spent about two hours on it. It’s just like the 30-minute toilet-bolt-cap job I did recently, which took 4 hours.

1. The pins holding the old group in don’t just “fall out,” as people claim they do, and you can’t just push them out with a punch. I had to bang the snot out of mine with a big hammer and a punch. They were really tight. I put a couple of blocks of wood on my bench and covered them with paper towels to prevent marring, and the pins came out. They are the same on both ends, so you can’t push them out the wrong way. Either way works.

2. The two smaller pins DO just fall out, and they do it while you’re working on the gun. If you let this happen, you’ll have to fiddle with it to get them back in, so don’t let it happen.

3. If your bolt lock doesn’t seem to want to let go, it’s because it’s stupidly designed. The manual contains some frustrating tripe about pulling the lock lever’s upper part to make it let go, which is counterintuitive. Forget all that. Pull the bolt back, pull the lever, let the lever go, and release the handle. This works.

4. You can buy a new bolt lock lever just about anywhere for $14 or less. Tandemkross makes a really neat one that hangs out where you can get at it. It will also release the bolt when you pull it back and let it go, so your 10/22 will be like a normal gun.

5. Tandemkross also makes a really neat magazine release lever. Other companies make them too, but I trust Tandemkross more than a random sweatshop in Shenzhen that sells via Amazon.

I decided to get a Ruger BX trigger, which is a nicer version of the standard trigger. The pull is a lot lighter. You can’t adjust it; at least not if you’re a typical user. I suppose a gun nerd could do it.

The BX trigger is a direct replacement. Sadly, it has no markings on it indicating that it’s a BX, so if you take your old trigger out and put both triggers down together, you are likely to install the wrong one when you get back to work.

You can also buy triggers costing a couple of hundred dollars. I don’t think a 10/22 rifle is capable of shooting accurately enough to make them worth it. The BX feels very good, and there is no way I’ll need anything better on a pistol with a red dot.

A hex nut fell on my workbench while I was working on the gun, and it matches the pitch of the screw that holds the handgrip on. There are no nuts in the manufacturer’s parts list or exploded views, and if you put the hex nut on the screw, there is no place in the gun where it will fit.

I kind of wonder if there was a nut on the bench, which stuck to my hand while I was fighting with the pistol and then fell off. If so, the matching pitch is an impressive coincidence. I put the gun together without it, and everything seems fine.

I have the above-mentioned Tandemkross parts on the way, so I will not have to keep suffering with the factory bolt lock and magazine release. I also bought a Shock Block, which is a thing that cushions the bolt when it flies back in the receiver. There is a steel pin in the rear of the receiver, and people say the bolt hits it.

There is a lot of argument about whether the bolt needs cushioning. Some say the bolt never hits the pin. Some say it only happens with fast ammunition. Some say it definitely happens when using a silencer. I figured it couldn’t hurt.

This is where my 10/22 efforts and knowledge stand right now. I want to punch the whole Ruger company in the face. I will try out the trigger tomorrow or the next day, and I’ll try the other stuff when it arrives.